Paintball Marker Help

[DrizztFan24]

Hey, folks, I just bought and Arikon Overlord Rx on Ebay and it arrived today. Problem is, everytime I try to shoot it the balls make it maybe 15 feet then drop. The rounds and the gun are both .68 caliber and adjusting the speed regulator hasn't done me any good.

I took it apart as much as I could (before one of my allan wrenches snapped) and replaced the O-rings on recommendation of a local that runs a woodsball arena (he is unfamiliar with the overlord, that was just his general step one).

So any help to be found? I am totally clueless and would love to get this fixed. Someone already offered to buy it for about $160 USD before it even arrived at my house.

[Thanatos 51-50]

Politely point out to your potential buyer that there's one available for less than the offered price on line (http://www.directpaintball.com/Ariakon-Overlord-RX-Paintball-Pistols-P20682.aspx) and you're not going to rip him off?

Back to fixing-you-gun, have you checked the feed mechanism and cleaned the barrel? Is your compressed gas good?

[DrizztFan24]

Politely point out to your potential buyer that there's one available for less than the offered price on line (http://www.directpaintball.com/Ariakon-Overlord-RX-Paintball-Pistols-P20682.aspx) and you're not going to rip him off?

Already did. He wanted the holster and extra mags this one has with it. Apparently he is a bit of a collector with well over two grand invested into his current gear.

Feed is good and the barrel is totally clean. No buildup and the ball detent is as it should be.