View Full Version : Internal Roller
I can't get it to work.
[roll0]
That's how you do it, right?
Gaelbert
2007-09-03, 11:14 PM
It looks like you're previewing it. Doing that can mess it up. Here's the code for rolling, I believe:
1d20+2
Let's try it then.
1d20+2
EDIT: I got nothing.
Gaelbert
2007-09-03, 11:19 PM
Don't put a v in the second bracket: [/roll]
Okay...
1d20+12
EDIT: Nope.
Gaelbert
2007-09-03, 11:22 PM
Put the v in the first part, but not the second:
Apparently I need 10 characters before I can post.
1d12+20
EDIT: Still nothing.
Gaelbert
2007-09-03, 11:24 PM
1d20+3
hope this works
Maybe it doesn't work in this section? Seriously, I run a campaign on these boards. I really should know how to use the roller...:smalleek:
Same here.
1d12+3
EDIT: That might be it. Let me try in another section.
Didn't work in the Dice Roll section, and I believe that's one part where it should always be useable.
Then again I used [rollv]4d6[roll] so that might have some bearing.
Vonriel
2007-09-03, 11:34 PM
Aye, dice rolling was disabled everywhere but Play-by-post games. So, the dice rolling forum, the alpha/beta/gamma thread subforums, etc. do. The Silly Message Board Games, however, don't have use of them, at least not last time I checked.
Let's see if I can find the old dice rolling thread...
Edit: Here (http://www.giantitp.com/forums/showthread.php?t=27768) is the thread first created after Rawhide installed the code for the dice roller on the forums. It should tell you everything you need to know.
I tested in tested in the dice rolling thread. Eh. No worries. I'll just use Invisible Castle.
Vonriel
2007-09-03, 11:39 PM
Ok. .
Powered by vBulletin® Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.